Model FT30, FT45
Assembly Instructions
(page 2)

          (Fig 4)                                    (Fig 5)                                  (Fig 6)

4
) GENTLY insert bolts through base and into holes in post, starting with the red one, and alternating between the two. If a bolt does not easily thread into the nut, turn it counter-clockwise full turn and try it again. You may have to do this 2 or 3 times before the bolt threads into the nut. Turn the bolt as far as possible with your fingers, then use the hex wrench. BE CAREFUL NOT TO BREAK THE WOOD BY OVERTIGHTENING (see Fig 4).

5) After you have tightened the bolts, the product should appear as in (Fig 5). Potition the post so that the base is flat against the floor. There will be some space between the wall and the base. This is normal. The top of the product will just touch the wall (See Fig 6).

6) Your Flying Tee is ready for scratching. Go get your cat.

7) If there are assembly questions or problems, please contact us by e-mail, first, if possible. There is also a "contact us" button on the entrance page of our web site.

Go to Feline Design's home

1450 Burgoyne Rd.
Downingtown, PA 19335
USA
e-mail: tommy@felinedesign.net

                                            Phone: 610-524-7940
                         
    web site: www.felinedesign.net